 |
 |
 |
|
|
|
[Sponsors] | ||||
is it possible to use macros with parameters? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 22, 2001, 07:16
|
is it possible to use macros with parameters?
|
#1 |
|
Guest
Posts: n/a
|
The subject is my question, and if it is possible then how? (I want to write a macro to read a cas,dat file then make plots and then hardcopy) Thanks! Máté
|
|
|
||
|
April 24, 2001, 10:16
|
Re: is it possible to use macros with parameters?
|
#2 |
|
Guest
Posts: n/a
|
I am not sure why you want to use macro. You can write a journal file to read cas dat file and then make plots hard copy etc.
|
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| twoPhaseEulerFoam - parameters | grjmell | OpenFOAM | 1 | June 16, 2011 08:13 |
| units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 03:58 |
| What are UDF macros C_T_S , C_T_AP,...???? | Asghari | FLUENT | 0 | January 28, 2007 10:54 |
| New to CFX-need explanations about mesh parameters | Cyril | CFX | 3 | November 24, 2006 06:33 |
| expert parameters of SST model? | David | CFX | 1 | December 2, 2005 06:36 |
Linear Mode
