axisymmetric postprocessing

April 25, 2001, 11:10

Hi everyone, I'm currently working on on 2D pipe and annular flow - meshing half of the required geometry in Gambit and defining one long edge as an axis. Once Fluent has come to a solution, I want to display the velocity contours, etc. of my geometry as a whole, (i.e. displaying both halves) - Is there a way to display or mirror the other half of the geometry to complete the picture?

April 25, 2001, 13:50

Go to Display-->Views and define Mirror Planes there.

April 25, 2001, 11:10	axisymmetric postprocessing	#1
merac Guest Posts: n/a	Hi everyone, I'm currently working on on 2D pipe and annular flow - meshing half of the required geometry in Gambit and defining one long edge as an axis. Once Fluent has come to a solution, I want to display the velocity contours, etc. of my geometry as a whole, (i.e. displaying both halves) - Is there a way to display or mirror the other half of the geometry to complete the picture?

April 25, 2001, 13:50	Re: axisymmetric postprocessing	#2
Xiao Hu Guest Posts: n/a	Go to Display-->Views and define Mirror Planes there.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
using fieldAverage library to average postprocessing	eelcovv	OpenFOAM Programming & Development	32	May 17, 2022 09:55
Difference of final temperature between a plane and an axisymmetric geometry	douchka	FLUENT	0	July 7, 2011 08:38
Axisymmetric Swirl	Arpit Tiwari	Main CFD Forum	1	September 15, 2010 05:45
Level set equation in axisymmetric 2-D flow	jinwon park	Main CFD Forum	0	February 26, 2008 16:26
Axisymmetric Flow	S. Kumar	Main CFD Forum	0	November 10, 2001 10:15