|
[Sponsors] |
June 29, 2013, 14:49 |
Giving Profiles
|
#1 |
Member
Join Date: Sep 2012
Location: FL
Posts: 79
Rep Power: 13 |
When I am giving PROFILE at inlet (using the point values from previous simulation), I am getting this error.
Error:cx-set-real-entry:wta[2](float) Error object :-1.#ind I could not understand this error. Can some one throw some light for me? |
|
June 30, 2013, 12:16 |
|
#2 |
Member
Join Date: Sep 2012
Location: FL
Posts: 79
Rep Power: 13 |
I tried writing the profile ( by giving some constant values) and then reading it. It is giving me the same error.
|
|
July 3, 2013, 01:35 |
|
#3 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
how looks your profile?
can you edit it here
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free surface flow settubg boundary conditions and plotting velocity profiles | prashanthreddyh | FLUENT | 2 | October 21, 2015 09:58 |
Stream-wise velocity profiles | girishg | STAR-CCM+ | 5 | March 30, 2013 11:40 |
Lid Driven Cavity velocity profiles | new_at_this | Main CFD Forum | 0 | December 22, 2011 16:04 |
Time-Varying Temperature Profiles | shepardsp | ANSYS | 3 | October 17, 2010 14:36 |
Problem in giving heat source | Sireesha | FLUENT | 1 | July 10, 2004 17:54 |