|
[Sponsors] |
July 10, 2001, 03:31 |
about error message in fluent
|
#1 |
Guest
Posts: n/a
|
Now I have a question when I simulate burning of gas.I use eddy dissipation reaction model,ideal gas ,couple implicit solver.
When i have got a good cold flow solution, I pacth 2000K in combustion zone.After some iterations,I've been getting this AMG solver error : Error: Internal error at line 719 in file 'amgif.c'. divergence detected in AMG solve. I've tried everything I can imagine!!! Would you give me some advice? Thanks a lot, in advance...... Devy 2001.7.10 |
|
July 10, 2001, 04:49 |
Re: about error message in fluent
|
#2 |
Guest
Posts: n/a
|
The problem is that you solution will not converge. There are several causes for this failure. Like a grid which is not good (skewness, connectivity). The RSM turbulunce model is very sensitive to these things. Maybe you should try another model first.
|
|
July 10, 2001, 05:38 |
Re: about error message in fluent
|
#3 |
Guest
Posts: n/a
|
Hi,
Thank you for your reply. After I have got a good cold flow solution, I pacth 2000K in combustion zone.After1000 or so iterations,Fluent suddenly can't continue to calculate and it also don't reduce the CFL. I think it is boundary conditions accounting for this error.I try to define one gas species fraction on boundary as zero diffusive flux,this problem doesn't happen.But the gas species fraction is physically value 1. Now I still don't know how to solve it. |
|
August 1, 2001, 05:10 |
Re: about error message in fluent
|
#4 |
Guest
Posts: n/a
|
one think you can do is to change the initial values. giving a nonzero value to the initials may converge your problem. and try to keep your under relaxation parameters low.
edvin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
A Problem of Fluent Interpreted UDF: parse error | knight | Fluent UDF and Scheme Programming | 25 | August 16, 2018 10:26 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |