|
[Sponsors] |
November 29, 2001, 13:53 |
SA-turbulent viscosity ratio-help
|
#1 |
Guest
Posts: n/a
|
Dear all
I am modelling some experimental results of mine for an airfoil in a wind tunnel using 5.5.14. However, when I am going to use the SA model in Fluent, I cannot find sufficient help to compute roughly the inlet turbulent viscosity ratio or the intensity and hydraulic diameter. Although when I use k-e model there is no problems getting the equations from the help menu. If somebody could help me either find the suitable equations in the help menu, although I maintain they are not that useful, or tell me them I would be very grateful. Cheers Andy |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turbulent viscosity ratio | Balaji | FLUENT | 5 | May 27, 2014 04:47 |
hel (turbulent viscosity ratio limited) for supersonic combustion problem | omar.2002bh | FLUENT | 2 | September 5, 2012 12:04 |
setting value of turbulent intensity and turbulent viscosity ratio in wind tunnel | nuimlabib | Main CFD Forum | 0 | August 4, 2009 01:05 |
On limiting to turbulent viscosity ratio! | varghese | FLUENT | 2 | November 15, 2003 09:56 |
Problem of Turbulent Viscosity Ratio Limited | David Yang | FLUENT | 3 | June 3, 2002 07:13 |