|
[Sponsors] |
November 30, 2001, 10:52 |
Auto-iterationing & converging
|
#1 |
Guest
Posts: n/a
|
Hello everyone,
I am programing extenal program that can execute Fluent on window NT. This program will automatially read data of out file from Fluent, and then will modify input value of journal file to execute Fluent. Repeating of this wok will be done until out data satisfy given conditions. But, the trouble is that I am not sure what Fluent leaves any symptom for completion of excution. How can I recognize that fluent execution is completed? Thanks J.W.Ryu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Converging Diverging Nozzle in OpenFOAM | danishdude | OpenFOAM Running, Solving & CFD | 1 | September 15, 2012 00:12 |
Wall scale not converging | arunraj | CFX | 1 | October 3, 2011 17:52 |
transient converging, but not steady | PHS- | FLUENT | 5 | July 25, 2011 14:25 |
solution not converging for fine mesh.. | saurabh.deshpande88 | FLUENT | 2 | February 2, 2010 10:23 |
shell auto ignition | cw | Siemens | 0 | August 21, 2008 17:55 |