 |
 |
 |
|
|
|
[Sponsors] | ||||
December 1, 2001, 12:48
|
modelling gas lift technology
|
#1 |
|
Guest
Posts: n/a
|
hi,
I am modelling a gas lift technology based on some literature i could find.It is a long tube and its length is 2000 m by 15 cm as its diameter of the tube.This extreme long tube cause very high value of meshing element and visionary unconvenience. How would i properly model a 'smaller' geometry? Thank you |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Modelling the heat transfer during compression and cooling of natural gas | pano | Main CFD Forum | 0 | December 10, 2010 15:53 |
| Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 08:56 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
| Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |
Linear Mode
