[cafer888]

Hello Everyone,

I am a master's student and I am working on a cfd modeling of fluidized bed dryer for wood shavings. I am very new on Ansys Fluent and using v19.2 and really excited about learning this software sof thats why I am already stuck with adding moisture content to solids and evaporating them.

Let me explain my current situation;
I have already prepared geometry and also modeled the fluidization without any issues and very happy about results. So now the next step is adding moisture ratio to wood shavings initially %45 and ı am expecting %5 at end of the simulation.

Can any of you specialists give me some tips about how to proceed ?

Thanks,