mass flow rate of a dispersion phase

February 24, 2002, 02:41

Hi, anybody,

I think you are so kind tell me that if I can calculate the mass flow rate of a dispersion phase at each outlet boundary. Now I'm simulating a separating device by FLUENT5.4. This device has two outlets. I want to know its separating efficiency. So I must know the mass flow rate at two outlets.

Sincerely, Paul

February 25, 2002, 23:19

Use Display-->Particle-Track panel. Set report type as 'summary'. Then Fluent reports escaped zone and particle number etc.

Sincerely, Jinwook

February 24, 2002, 02:41	mass flow rate of a dispersion phase	#1
Paul Guest Posts: n/a	Hi, anybody, I think you are so kind tell me that if I can calculate the mass flow rate of a dispersion phase at each outlet boundary. Now I'm simulating a separating device by FLUENT5.4. This device has two outlets. I want to know its separating efficiency. So I must know the mass flow rate at two outlets. Sincerely, Paul

February 25, 2002, 23:19	Re: mass flow rate of a dispersion phase	#2
Jin-Wook LEE Guest Posts: n/a	Use Display-->Particle-Track panel. Set report type as 'summary'. Then Fluent reports escaped zone and particle number etc. Sincerely, Jinwook

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow rate not conserved in turbomachine, interface defined wrong?	wildli	FLUENT	3	September 15, 2022 12:19
Mass flow rate: calculation v/s computation	beguxa	FLUENT	5	December 2, 2018 21:02
UDF to measure Mass Flow Rate	a.lynchy	Fluent UDF and Scheme Programming	31	October 4, 2018 14:10
particle, parcel and mass flow rate balance	flybird	FLUENT	0	May 24, 2007 10:44
compressible two phase flow in CFX4.4	youngan	CFX	0	July 1, 2003 23:32