 |
 |
 |
|
|
|
[Sponsors] | ||||
March 15, 2002, 15:33
|
Multi-components in a porous zone
|
#1 |
|
Guest
Posts: n/a
|
The fluid for a porous zone is that we specify in the "species-model", since Iam doing a multi-component flow.But if I want to specify the concentration of different components in that fluid(porous) zone , how do I do that? Thanks to all.
|
|
|
||
|
March 17, 2002, 18:31
|
Re: Multi-components in a porous zone
|
#2 |
|
Guest
Posts: n/a
|
Does this make sense???
Fluent wil solve for these concentrations - mass fractions within the domain!!! You can set b/c though! Greg |
|
|
|
||
|
March 17, 2002, 18:49
|
Re: Multi-components in a porous zone
|
#3 |
|
Guest
Posts: n/a
|
Hi Greg,
Inside the porous zone, I want to specify the concentration of the(fluid)components initially before solving.Like,I select a mixture and then specify the initial concentration of the components of the mixture.Is this possible?Thanx---Shankar. |
|
|
|
||
|
March 17, 2002, 19:09
|
Re: Multi-components in a porous zone
|
#4 |
|
Guest
Posts: n/a
|
Ok, that should be no problem - just do it as normal. Greg
|
|
|
|
||
|
March 19, 2002, 17:27
|
Re: Multi-components in a porous zone
|
#5 |
|
Guest
Posts: n/a
|
Hi Greg, How do I go about specifying the initial mass fractions of different components inside the porous zone, or can you tell me which chapter of the user manual will be able to guide me through.Thanks.-Shankar
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| Need help!:Particle flow through porous zone | lig | FLUENT | 0 | April 26, 2010 00:47 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
| Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |
Linear Mode
