Home > Forums > FLUENT

Unite faces problem

Mark Forums Read

Reply

March 23, 2002, 08:53	Unite faces problem	#1
Alex Guest Posts: n/a	Hi all, I'm trying to unite 2 faces with 2 common edges. Face.1 is ( and face.2 is ). They are real. The geometry comes from an IGS file created with CENTAUR (imported as GENERIC). Issue#1: my unite face window title say "UNITE FACES" and not "UNITE REAL FACES" as described in Gambit manual. Issue#2: unite operation seems to be performed but no new face is generated Command> face unite faces "face.20" "face.21" real Uniting faces face.20 and face.21 And there it stops!!! Any clue about what's going on? Many thanks, Alex

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
problem due to reconstructPar?	doubtsincfd	OpenFOAM	0	June 3, 2011 16:16
problem : "reversed flow in 77 faces on outflow 12."	aliamini	FLUENT	14	June 27, 2009 02:57
Converting Virtual Faces to Real Faces in Gambit	gstraw	Main CFD Forum	0	June 19, 2009 07:11
Error to re-open fluent case file	J.Gimbun	FLUENT	0	April 27, 2006 08:42

All times are GMT -4. The time now is 11:07.