CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

mold filling in Fluent ?

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   April 8, 2002, 21:24
Default mold filling in Fluent ?
  #1
Tony
Guest
 
Posts: n/a
Hi all, 1) I tried to use the vof model in FLUENT to solve the mold filling problem in a simple 2d slot. The water inlet is from left side and right side is the outlet of the air phase, both top and bottom walls are stationary and no-slip. In this case only implict vof can give converged result but with diffused interfaces over several cells, all the other options ( donor-accetpor, or geo-construction) failed to give accurate interface shape and diverged before completely filled. Any suggestion? 2) I know that the no-slip assumption at the triple-contact point on the wall will cause the unreasonable prediction of front shape. In Flunt, is it possible to use a dynamic bounary condition?, that is in the water phase, the wall is no-slip but in the air phase the wall is outlet. Thanks in advance
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
How to open Icem mesh in Ansys Fluent? emmkell FLUENT 26 June 9, 2015 15:38
Two questions on Fluent UDF Steven Fluent UDF and Scheme Programming 4 September 20, 2013 16:30
Fluent 6.3 32bit vs Fluent 12.0 64bit ibex7 FLUENT 7 April 18, 2011 02:44
mold filling John CFX 2 October 14, 2008 11:03
Regarding mold filling simulation in Fluent Nitin Pathak FLUENT 0 August 10, 2007 14:19


All times are GMT -4. The time now is 17:10.