 |
 |
 |
|
|
|
[Sponsors] | ||||
how to deal with phase-change heat exchanger? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 11, 2002, 10:39
|
how to deal with phase-change heat exchanger?
|
#1 |
|
Guest
Posts: n/a
|
Fluent 6.0 has offered the heat exchanger model, but i found it can only handle one-phase model(radiator), but we hope this model could deal with phase-change model(condenser,etc), any expert could tell me how to make an approperate modification?
|
|
|
||
|
April 16, 2002, 21:59
|
Re: how to deal with phase-change heat exchanger?
|
#2 |
|
Guest
Posts: n/a
|
You should not use this model, and you could do with UDFs writing source terms.
|
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Double pipe heat exchanger | mohcin | FLUENT | 21 | June 18, 2016 14:19 |
| Heat Exchanger Simulation | tightaznbreaka | FLUENT | 0 | March 18, 2010 15:45 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
| Heat Exchanger Model - urgent | JSM | FLUENT | 6 | September 22, 2007 04:25 |
| help needed about phase change | Yanhu Guo | Main CFD Forum | 4 | January 23, 2001 23:16 |
Linear Mode
