 |
 |
 |
|
|
|
[Sponsors] | ||||
May 5, 2002, 11:58
|
GAMBIT start
|
#1 |
|
Guest
Posts: n/a
|
when I input GAMBIT (FILEMANE), an error message shows: Cannot open connect stream.
Somebody can tell me, how should I do? Thank you. |
|
|
||
|
May 6, 2002, 05:10
|
Re: GAMBIT start
|
#2 |
|
Guest
Posts: n/a
|
You can now start Gambit without specifying the id name. Then from the GUI you can load your project.
|
|
|
|
||
|
June 1, 2002, 02:56
|
Re: GAMBIT start
|
#3 |
|
Guest
Posts: n/a
|
||
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Canīt start GAMBIT | zalho | ANSYS Meshing & Geometry | 16 | May 21, 2012 16:28 |
| gambit crashed | mbgnfrx2 | FLUENT | 1 | August 13, 2009 03:31 |
| gambit start | Zhiqiang An | FLUENT | 2 | March 31, 2003 10:34 |
| Generating big meshes with GAMBIT on NT | Andrew Ooi | FLUENT | 12 | February 2, 2000 22:26 |
| Lets start the public domain CFD-Project! | Heinz Wilkening | Main CFD Forum | 3 | March 11, 1999 22:55 |
Linear Mode
