|
[Sponsors] |
May 15, 2002, 10:04 |
Lawn mover Deck
|
#1 |
Guest
Posts: n/a
|
Dear Gambit users,
I have generated a simple geometry of lawn mover deck ( cylindrical deck, single blade, and brick shaped boundary surrounding deck) During meshing, how should I proceed in selecting the volumes? I would really appreciate if anyone,who previously did this type of problem, could assist me giving some guidelines how to do this type of problems. Step by step procedure would be very helpful to me. Thanks for your patience. Sridhar. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Output deck from ANSA for OpenFOAM use | Kattie | OpenFOAM Meshing & Mesh Conversion | 10 | February 2, 2011 07:46 |
Lawn mower decks | Paul | Main CFD Forum | 3 | May 22, 2003 12:45 |
cold runner deck for injection rubber | Bernard Gullett | Main CFD Forum | 0 | November 23, 1998 22:40 |