CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Plain-orifice-atomizer (http://www.cfd-online.com/Forums/fluent/29792-plain-orifice-atomizer.html)

Hiranya May 23, 2002 05:36

Plain-orifice-atomizer
 
Hi!

Could you please give me some explanation about "Azimuthal Start and Stop angle" for Plain-orifice-atomizer.

Suppose there is a case where fluid flows thro' a 3D rectangular duct into which I inject liquid from the middle of botttom surface at a certain distance from the inlet. In this case what should be this Start and Stop angle value.

Thanking you in advance, Hiranya

Hiranya May 24, 2002 09:02

Re: Plain-orifice-atomizer
 
I got the answer.


All times are GMT -4. The time now is 23:42.