Monitor mass flux in multiphase model
 

Hi,

I am modeling gas-particulate phase flow using FLUENT 6 Eulerian model. I hope to monitor the mass flow rate of the solid phase along the exit surface. However, on the panel Solver>Monitors..., when I choose "mass flow rate", there is no place for me to choose the phase that I will monotor. So, in this case, how can I obtain the mas flow rate of one of the phases?

Thank you in advance.

-Derek

Re: Monitor mass flux in multiphase model
 

Hi Derek;

in fluent panel , you use text command :
: report
: mass-flow
: chose your phase

fouzi