|
[Sponsors] |
May 28, 2002, 11:24 |
Hi Evan( Rosenbaum), Pl. help.........
|
#1 |
Guest
Posts: n/a
|
Hi Evan,
In reply to my message:- http://www.cfd-online.com/Forum/fluent.cgi?read=8044 , You wrote:- "FLUENT can't do what you want. The porous medium is simply a fluid with and additional, possibly orthotropic, momentum sink term. Because the porous medium is a fluid and not a solid, you will not get proper shear stresses at the interface and you cannot include the effects of any surface roughness." Then, I posted http://www.cfd-online.com/Forum/fluent.cgi?read=8046 , which reads.. "If it is not possible with FLUENT, do you know if there is any alternative solution/other software which can do this? Is it not possible to treat the sand-water interface as solid surface with some porosity and make it a 'Velocity Inlet' B.C. there? " But there is no reply from you. And you did not write your e-mail address, so I am again posting this mail. Please reply the above querry. Waiting eagerly for your Reply. Thanks. Sharad Dugad |
|
May 30, 2002, 02:24 |
Re: Hi Evan( Rosenbaum), Pl. help.........
|
#2 |
Guest
Posts: n/a
|
Hi all,
If any one knows Evan's e-mail address pl. reply. Also I wish if any one can help me on this problem!! Sharad Dugad |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BouyantFoam | antopnieta | OpenFOAM Running, Solving & CFD | 8 | February 4, 2008 08:22 |
What is the meaning of | francesco_b | OpenFOAM | 3 | February 4, 2008 05:54 |