|
[Sponsors] |
May 23, 2002, 09:46 |
Monitor mass flux in multiphase model
|
#1 |
Guest
Posts: n/a
|
Hi,
I am modeling gas-particulate phase flow using FLUENT 6 Eulerian model. I hope to monitor the mass flow rate of the solid phase along the exit surface. However, on the panel Solver>Monitors..., when I choose "mass flow rate", there is no place for me to choose the phase that I will monotor. So, in this case, how can I obtain the mas flow rate of one of the phases? Thank you in advance. -Derek |
|
May 30, 2002, 15:18 |
Re: Monitor mass flux in multiphase model
|
#2 |
Guest
Posts: n/a
|
Hi Derek;
in fluent panel , you use text command : : report : mass-flow : chose your phase fouzi |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 07:18 |
Selecting the appropriate multiphase model and radiation model | panos_metal | FLUENT | 0 | June 18, 2010 07:58 |
Multiphase model | capilor | FLUENT | 0 | June 1, 2010 12:24 |
air and water vapour mixture - multiphase model | Saba | FLUENT | 0 | February 10, 2009 12:05 |
multiphase mixing Problem with MRF model in MixSim | Srinivas | FLUENT | 0 | October 17, 2005 06:35 |