advise please!
 

Hi fluent Users, In DPM, I recive these 2 message. 1-Reversed flow in x faces on pressure outlet 2-plain Orifice Nozzle is single phase! 3-In spinte of the above note, it's written that the solution is converged! Please help if you have any solution in mind! Thank you dear partisans

Re: advise please!
 

Oh no! I have been receiving these messages for more than a year. What I feel is that your boundary conditions are not set properly. For me, when I increase the flow rate at inlet of domain, "Reversed Flow in X faces of domain" use to go away...hope this helps Cheers! Atul