CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Segmentation Voilation (

Duc June 19, 2002 06:15

Segmentation Voilation
Dear Fluent Experts,

I was solving a unsteady compressible problem, when the solution converged within the time steps I set, it gave me the following messages:

Error: Fluent.5.5.14 recieved a fatal signal (SEGMENTATION VOILATION) Error object: #f

Iterating again, would give me a quicker convergence with the same error message.

Does anyone know what the message means?

Many thanks and regards, Duc Nhin Ha

reza vahedi June 19, 2002 09:52

Re: Segmentation Voilation
I think the problem might be in setting one of your boundary conditions.

Duc June 19, 2002 10:06

Re: Segmentation Voilation

What I have is a thin rectangular film, the upper boundary is an oscillating (in the Y dir) wall defined by an unsteady velocity UDF. The lower wall is stationary, the left and right boundaries are exits open to ambient, I set those as Pressure Outlets. It is clear that I haven't defined an inlet for the flow, as both pressure outlets also acts as inlets, depending if the film is compressed or depressed by the moving wall. Are these boundaries practical for Fluent?

Once again, thank you for your help.

Duc Nhin Ha

All times are GMT -4. The time now is 19:57.