Help.. Source terms..

July 3, 2002, 09:25

Hi all,

(1)Can I use an edge of a fluid continum face as inlet using "Source term" option in 'Fluid' panel?

Fluent Manual suggests use of this for a tiny element/cell.

(2)If the ans. to (1)is yes, then how to calculate the mass & momentum sources for the edge which is in the X direction(parallel to X-dir)? Shall I have to input X-momentum source or Y-momentum?

Als, How to specify K and epsilon for the same?

I am using Fluent 5.5 for 2-D model.

Waiting for help. Thanx in advance.

July 4, 2002, 00:06

Can only specify mass/momentum source in fluid cells.

July 3, 2002, 09:25	Help.. Source terms..	#1
Diana Guest Posts: n/a	Hi all, (1)Can I use an edge of a fluid continum face as inlet using "Source term" option in 'Fluid' panel? Fluent Manual suggests use of this for a tiny element/cell. (2)If the ans. to (1)is yes, then how to calculate the mass & momentum sources for the edge which is in the X direction(parallel to X-dir)? Shall I have to input X-momentum source or Y-momentum? Als, How to specify K and epsilon for the same? I am using Fluent 5.5 for 2-D model. Waiting for help. Thanx in advance.

July 4, 2002, 00:06	Re: Help.. Source terms..	#2
Lanre Guest Posts: n/a	Can only specify mass/momentum source in fluid cells.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
wmake compiling new solver	mksca	OpenFOAM Programming & Development	14	June 22, 2018 06:29
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 16:02
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51