 |
 |
 |
|
|
|
[Sponsors] | ||||
July 18, 2002, 22:39
|
Temperature at grid points..
|
#1 |
|
Guest
Posts: n/a
|
DEar All,
Im trying to input volumetric heat generation inside an the annulus of a small duct. After iteration i realise that there arent any temprature distribution inside the annulus..jus shows an even red coloured region of maximum temperature. Is there a way to check the temperature at everygrid point in the inside of the annulus?..I have to locate the point where the maximum temeprature occurs.. Plz help Thnk u Elana |
|
|
||
|
July 21, 2002, 16:53
|
Re: Temperature at grid points..
|
#2 |
|
Guest
Posts: n/a
|
Change auto scale to set range and change the magnitude according to the know temp., range. Play with set range till you see the desired contour.
|
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| adjust inlet temperature depending on values of monitor points (groovyBC) | braennstroem | OpenFOAM Running, Solving & CFD | 2 | May 31, 2011 13:45 |
| BlockMeshmergePatchPairs | hjasak | OpenFOAM Native Meshers: blockMesh | 11 | August 15, 2008 07:36 |
| Calculation of the Governing Equations | Mihail | CFX | 5 | July 25, 2008 17:29 |
| Temperature went outside of its upper limit | Atit Koonsrisuk | CFX | 0 | January 8, 2004 11:43 |
| Temperature in vessel during throttling process | Astrid | Main CFD Forum | 2 | January 31, 2001 02:34 |
Linear Mode
