CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Continuity Residual

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   July 25, 2002, 16:13
Default Continuity Residual
  #1
Greg
Guest
 
Posts: n/a
I'm modeling a 3-D heat exchanger that has opposite direction laminar water flows on either side of a thin aluminum plate. The remainder of the water is bounded by PVC.

I've found that at an Energy convergence criterion of 1e-6, the heat exchanger does not have balanced heat flows. But iterating Energy to 1e-7 and beyond greatly improves this situation. It also more closely agrees with experimental data.

But when I continue these iterations, I notice that the continuity residual oscillates between 1e-3 and 1e-4 (converged by Fluent's default criterion) while the X/Y/Z velocities and Energy continue a nice downward slope. I'd like to know what factors may cause the continuity residual to behave this way.

Also, I've found that decreasing the momentum underrelaxation factor causes the continuity residual to immediately drop by a noticeable amount. But it then continues its oscillatory behavior at the new lower value. Any explanations out there?

I'm using first order upwind discretization and simplec PV coupling. I've lowered the momentum UR factor to .2 and the Energy UR factor to .9. All others are default values.

Thank you!
  Reply With Quote

Old   July 26, 2002, 13:25
Default Re: Continuity Residual
  #2
Evan Rosenbaum
Guest
 
Posts: n/a
The oscillating continuity residual could mean that the magnitude of your residual is on the same order as the numerical accuracy of the calculations. It doesn't necessarily mean that anything is wrong.
  Reply With Quote

Old   July 26, 2002, 13:35
Default Re: Continuity Residual
  #3
Laika
Guest
 
Posts: n/a
I agree with Evan. Have a look at your mass balance. Or track an other value during iteration using monitors.

Laika, still orbiting
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Extrusion with OpenFoam problem No. Iterations 0 Lord Kelvin OpenFOAM Running, Solving & CFD 8 March 28, 2016 12:08
How to write k and epsilon before the abnormal end xiuying OpenFOAM Running, Solving & CFD 8 August 27, 2013 16:33
Orifice Plate with a fully developed flow - Problems with convergence jonmec OpenFOAM Running, Solving & CFD 3 July 28, 2011 06:24
Differences between serial and parallel runs carsten OpenFOAM Bugs 11 September 12, 2008 12:16
Could anybody help me see this error and give help liugx212 OpenFOAM Running, Solving & CFD 3 January 4, 2006 19:07


All times are GMT -4. The time now is 02:17.