CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

unnecessary wall(bc)-help needed

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   August 30, 2002, 11:27
Default unnecessary wall(bc)-help needed
  #1
Shankar
Guest
 
Posts: n/a
In my geometry there are 2 volumes like a pipe (1 volume) opening in to a container(2nd volume).After meshing, in the first volume the tip of the pipe by default(when the mesh is exported to fluent) is set as wall(boundary condition), but clearly that shouldnt be a wall.Any suggestions?Thanks. Shankar.
  Reply With Quote

Old   August 31, 2002, 14:13
Default Re: unnecessary wall(bc)-help needed
  #2
Taher
Guest
 
Posts: n/a
Sure you must specify that boundary as interior manually .
  Reply With Quote

Old   September 1, 2002, 04:34
Default Re: unnecessary wall(bc)-help needed
  #3
david
Guest
 
Posts: n/a
If you don't specify the interface between two fluid volumes, by default gambit used to consider this as an interior. Funny thing is this feature doesn't work in the latest version of Gambit sometimes.

DC
  Reply With Quote

Old   September 2, 2002, 18:29
Default Re: unnecessary wall(bc)-help needed
  #4
Shankar
Guest
 
Posts: n/a
Thanks to both of you.I tried to specify it as "interior" manually, but when exported Fluent says that particular face cannot be specified as "interior".
  Reply With Quote

Old   September 3, 2002, 02:48
Default Re: unnecessary wall(bc)-help needed
  #5
david
Guest
 
Posts: n/a
ha ha this is the latest beauty of gambit !! Try try again and again !! DC
  Reply With Quote

Old   September 3, 2002, 12:27
Default Re: unnecessary wall(bc)-help needed
  #6
varghese
Guest
 
Posts: n/a
Dear Shankar,

I would suggest you to carefully check the connectivity of the two volumes. When they are not really connected, an unnecessary face is formed, in between.This usually occurs when you split the geometries.

Greetings,

Varghese
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
a CFD software is needed... maxgzc Main CFD Forum 3 September 27, 2011 01:51
no rules for target *Foam.dep which needed... goodkid OpenFOAM Programming & Development 2 May 12, 2011 20:54
Mesh generation software is needed H.Dou Main CFD Forum 12 May 4, 2011 15:20
a dissertation in ETD needed very much LiQiang Main CFD Forum 0 March 11, 2005 04:09
CFD Software Engineer needed in Fort Worth, Texas Ross Main CFD Forum 0 November 19, 2001 15:48


All times are GMT -4. The time now is 13:04.