|
[Sponsors] |
August 30, 2002, 11:27 |
unnecessary wall(bc)-help needed
|
#1 |
Guest
Posts: n/a
|
In my geometry there are 2 volumes like a pipe (1 volume) opening in to a container(2nd volume).After meshing, in the first volume the tip of the pipe by default(when the mesh is exported to fluent) is set as wall(boundary condition), but clearly that shouldnt be a wall.Any suggestions?Thanks. Shankar.
|
|
August 31, 2002, 14:13 |
Re: unnecessary wall(bc)-help needed
|
#2 |
Guest
Posts: n/a
|
Sure you must specify that boundary as interior manually .
|
|
September 1, 2002, 04:34 |
Re: unnecessary wall(bc)-help needed
|
#3 |
Guest
Posts: n/a
|
If you don't specify the interface between two fluid volumes, by default gambit used to consider this as an interior. Funny thing is this feature doesn't work in the latest version of Gambit sometimes.
DC |
|
September 2, 2002, 18:29 |
Re: unnecessary wall(bc)-help needed
|
#4 |
Guest
Posts: n/a
|
Thanks to both of you.I tried to specify it as "interior" manually, but when exported Fluent says that particular face cannot be specified as "interior".
|
|
September 3, 2002, 02:48 |
Re: unnecessary wall(bc)-help needed
|
#5 |
Guest
Posts: n/a
|
ha ha this is the latest beauty of gambit !! Try try again and again !! DC
|
|
September 3, 2002, 12:27 |
Re: unnecessary wall(bc)-help needed
|
#6 |
Guest
Posts: n/a
|
Dear Shankar,
I would suggest you to carefully check the connectivity of the two volumes. When they are not really connected, an unnecessary face is formed, in between.This usually occurs when you split the geometries. Greetings, Varghese |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
a CFD software is needed... | maxgzc | Main CFD Forum | 3 | September 27, 2011 01:51 |
no rules for target *Foam.dep which needed... | goodkid | OpenFOAM Programming & Development | 2 | May 12, 2011 20:54 |
Mesh generation software is needed | H.Dou | Main CFD Forum | 12 | May 4, 2011 15:20 |
a dissertation in ETD needed very much | LiQiang | Main CFD Forum | 0 | March 11, 2005 03:09 |
CFD Software Engineer needed in Fort Worth, Texas | Ross | Main CFD Forum | 0 | November 19, 2001 14:48 |