Home > Forums > FLUENT

swirl specification

Mark Forums Read

Reply

August 31, 2002, 03:00	swirl specification	#1
Prasad Laxman Kane Guest Posts: n/a	hi all I am handling a duct problem with four inlets. I have to specify swirl at two inlets, with angle of +/- 10 deg. How to specify ? thanks and regards prasad laxman kane

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Howe to get swirl velocity component in 2D axisymtric swirl modeling	Perra	Fluent UDF and Scheme Programming	1	December 12, 2009 02:37
Swirl in Pressure Swirl Atomizer	varunrajendra	FLUENT	0	August 19, 2009 12:09
Quantifying Swirl	Ianto	Main CFD Forum	0	April 27, 2009 10:54
Re: swirl specification	Christian	FLUENT	0	September 2, 2002 08:12
Swirl in backflow on pressure outlets	Jonas Larsson	FLUENT	17	February 3, 2000 02:14

All times are GMT -4. The time now is 10:51.