|
[Sponsors] |
September 1, 2002, 05:08 |
Urgent- How to call out .OUT files?
|
#1 |
Guest
Posts: n/a
|
Helo all,
I did some transient simulation and during the time steps, I have set some monitors to plot concentration of a species with flow time. The monitors are saved as .OUT file in my directory. My question is, after exiting from Fluent, the next time I restart Fluent, how do I call out the .OUT file to look at my plots? |
|
September 2, 2002, 05:02 |
Re: Urgent- How to call out .OUT files?
|
#2 |
Guest
Posts: n/a
|
hi there
depending on your version, the following should work. start Fluent, in the GUI on the top menu, got to Plot, File, click Add on the right hand side, and then you can plot the file. add more files to plot on the same graph... |
|
September 2, 2002, 20:47 |
Re: Urgent- How to call out .OUT files?
|
#3 |
Guest
Posts: n/a
|
oK thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF issue | MASOUD | Fluent UDF and Scheme Programming | 14 | December 6, 2012 13:39 |
How to call FORTRAN files as UDF? | Ehsan-F | Fluent UDF and Scheme Programming | 6 | September 11, 2012 11:03 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |