 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2002, 18:45
|
Reynolds Stress Model
|
#1 |
|
Guest
Posts: n/a
|
Dear Sir:
I am studing a problem of airflow in rooms. The program was converged with Standard K-EP model. However as the Reynolds Stress Model was turn-on an error message of "floating point devided by zero" was shown. The Reynolds Stress was specified by K and Ep. Is any special issure need to take care about when using the RSM? Any comments will be greatly appreciated. HC Lin |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blow up of reynolds stress turbulence model | newbee | OpenFOAM Running, Solving & CFD | 4 | August 12, 2010 05:10 |
| SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 16:15 |
| UDF in Re stress model | Jihwan | FLUENT | 0 | February 28, 2007 03:49 |
| Any mesh limitation for SSG Reynolds Stress Model? | Sam | Main CFD Forum | 1 | October 13, 2005 12:34 |
| Algebraic Stress Model and Collocated grid | Keur | Main CFD Forum | 0 | May 31, 2005 21:46 |
Linear Mode
