CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Urgent help for mixing plane

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 11, 2002, 05:35
Default Urgent help for mixing plane
  #1
cherry
Guest
 
Posts: n/a
hello everyone:

I am carrying out a unsteady simulation for centrifugal compressor stage.in order to give a good initial condition for unsteady solution, steady simulation using mixing plane is done.the solve and boundary condition are followed:coupled-explicit solver,pressure-inlet,pressure-outlet.

when the simulation is done for some iterations ,the residual doen't go down,and mass flow rate that be monitored at the diffuser outlet change at a very small range. but the mass flow rate of impeller inlet,diffuser oulet,and the two side of mixing plane are not equal. such asinlet): 0.39389926 (outlet): -0.38044581 two side of mixing plane(inlet1): 0.8149088 (outlet1): -0.85761952 .i don't know the reason. i need your help urgently,thank you very much.

sincerely

cherry
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Using a Plane id in Fluent UDF cdf_user Fluent UDF and Scheme Programming 13 October 17, 2023 01:06
[Gmsh] Problem with Gmsh nishant_hull OpenFOAM Meshing & Mesh Conversion 23 August 5, 2015 03:09
Meshing a Mixing Plane using ICEM Will Anderson FLUENT 0 November 6, 2010 18:08
[Gmsh] boundaries with gmshToFoam‏ ouafa OpenFOAM Meshing & Mesh Conversion 7 May 21, 2010 13:43
URGENT !!! DPM & mixing plane alex FLUENT 0 December 8, 2005 11:16


All times are GMT -4. The time now is 09:33.