|
[Sponsors] |
December 13, 2002, 07:33 |
problem in results
|
#1 |
Guest
Posts: n/a
|
I am modelling the laminar flow in the curved duct of square cross section. My problem is when I use the low Dean number equal 150, I have two counters rotating secondary vortices. Or the critical Dean number in my geometry is 150 (ie at Dn=150, logically I found four counters rotating secondary vortices) Please give me some help, Thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
combustion problem | mcnair | CFX | 9 | March 22, 2011 14:06 |
Problem with cfx Solver Results | Ordoumpozanis | CFX | 4 | August 27, 2008 11:54 |
Problem with reconstructing parallel results | qtian | OpenFOAM Running, Solving & CFD | 1 | May 15, 2008 17:30 |
benchmark results | stefan | Siemens | 3 | September 10, 2001 09:48 |