how to make a face of projected edge -- CFD Online Discussion Forums

December 20, 2002, 12:42	how to make a face of projected edge	#1
Parshant Dhand Guest Posts: n/a	Hi there, if i draw a circle in GAMBIT and then project it on a cylinder face, then what i get on the surface of cylinder is an edge, my question is how can i make it a face so that i can sweep a cylinder volume from this face. please anyone help.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
Meshing a Sphere	Ajay	FLUENT	10	September 3, 2016 14:18
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Check the skewnesses of your face meshes and make sure the face mesh sizes are not to	sophie-l	Main CFD Forum	1	April 13, 2009 19:16
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 04:26

All times are GMT -4. The time now is 05:56.