|
[Sponsors] |
December 19, 2002, 23:17 |
Gambit - Some regions not to be meshed ?
|
#1 |
Guest
Posts: n/a
|
After importing IGES file to Gambit, is it possible to leave some regions without meshing. Since that region is coneected to some lower or higer topologies, deleting that region is not possible. Anyother way is there to delte those region which are connected to some other topologies?
Or Without deleting, how to specify those region while meshing? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Converting Fluent mesh files to Gambit neutral files | samuelkc | ANSYS Meshing & Geometry | 9 | April 21, 2021 06:28 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |