 |
 |
 |
|
|
|
[Sponsors] | ||||
January 13, 2003, 01:27
|
Temperature limination
|
#1 |
|
Guest
Posts: n/a
|
hello,everyone When the fluent is iterating ,fluent will tell me "tempertature limination is 1K on some node",what should I do?
|
|
|
||
|
January 16, 2003, 02:47
|
Re: Temperature limination
|
#2 |
|
Guest
Posts: n/a
|
Hi,
You have to check your mesh quality and your BC. The mesh quality is recommended that the skewness is less than 0.90. Or, Under-relaxation factor should be changed to small value. Regards, |
|
|
|
||
|
January 17, 2003, 21:09
|
Re: Temperature limination
|
#3 |
|
Guest
Posts: n/a
|
keil, thank u very much! zhhuang
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 06:36 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
| Bulk temperature Tf is obtained from total or static temperature? | NPU_conanxie | FLUENT | 0 | March 30, 2011 05:56 |
| monitoring point of total temperature | rogbrito | FLUENT | 0 | June 21, 2009 17:31 |
| High temperature methane+air | Peter | FLUENT | 5 | January 26, 2009 18:04 |
Linear Mode
