|
[Sponsors] |
January 13, 2003, 02:27 |
Temperature limination
|
#1 |
Guest
Posts: n/a
|
hello,everyone When the fluent is iterating ,fluent will tell me "tempertature limination is 1K on some node",what should I do?
|
|
January 16, 2003, 03:47 |
Re: Temperature limination
|
#2 |
Guest
Posts: n/a
|
Hi,
You have to check your mesh quality and your BC. The mesh quality is recommended that the skewness is less than 0.90. Or, Under-relaxation factor should be changed to small value. Regards, |
|
January 17, 2003, 22:09 |
Re: Temperature limination
|
#3 |
Guest
Posts: n/a
|
keil, thank u very much! zhhuang
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 07:36 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 07:27 |
Bulk temperature Tf is obtained from total or static temperature? | NPU_conanxie | FLUENT | 0 | March 30, 2011 06:56 |
monitoring point of total temperature | rogbrito | FLUENT | 0 | June 21, 2009 18:31 |
High temperature methane+air | Peter | FLUENT | 5 | January 26, 2009 19:04 |