|
[Sponsors] |
February 28, 2003, 05:33 |
Tip of the week
|
#1 |
Guest
Posts: n/a
|
Ever wondered why you can only select 'mass imbalance' when you want to display contours of your residuals? I did. And now I found out it can be changed. In the cortex window type:
/solve/set/expert One the questions that will pop up is "Save cell residuals for post-processing? [no]" Type "y" and behold, all residuals are now available for postprocessing. I wonder why this is not on by default? |
|
February 28, 2003, 05:37 |
Re: Tip of the week
|
#2 |
Guest
Posts: n/a
|
Hi Erwin,
This is very good tip, especially for "debuging" fluid flow cases. Regards, ff |
|
March 3, 2003, 09:34 |
Re: Tip of the week
|
#3 |
Guest
Posts: n/a
|
Yeah, great tip. But does this work in transient calculation ???
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blade tip with tetra/prism method | vinc | ANSYS Meshing & Geometry | 0 | May 17, 2011 15:22 |
[ICEM] Structured Mesh 3D Wing Tip | Michiel | ANSYS Meshing & Geometry | 5 | October 21, 2010 08:39 |
Meshing in tip clearance. | me | Siemens | 0 | August 25, 2008 03:20 |
Tip Clearance | Liam | CFX | 3 | September 7, 2005 05:30 |
Tip Clearance | Drona | CFX | 0 | October 17, 2002 05:25 |