 |
 |
 |
|
|
|
[Sponsors] | ||||
March 5, 2003, 20:07
|
how to treat left handed faces
|
#1 |
|
Guest
Posts: n/a
|
when performing the Grid check, it reports that there are 2 left handed faces and grid check failed. How to remove these left-haded faces? Do these left handed faces affect the simulation? Thanks!
|
|
|
||
|
March 10, 2003, 07:08
|
Re: how to treat left handed faces
|
#2 |
|
Guest
Posts: n/a
|
With a failed grid check, i don't think you can run any iterations.
If you are using Gambit, you can use the grid check function in Gambit to help you identify where exactly the problem may lie. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
| left handed faces | Vincent | FLUENT | 1 | January 8, 2006 01:47 |
Linear Mode
