|
[Sponsors] |
April 5, 2003, 22:26 |
regarding dynamics mesh?
|
#1 |
Guest
Posts: n/a
|
HI,
I would try to simulate a simple problem before a complecated situation. I saw UDF manual provided by FLUENT.INC., but couldn't understand. My simple situation is that upper wall(rigid body) is moving up and down with a sinusoidal function in a parallel plate. Inlet velocity is given uniformly. No-slip condition is given in lower wall. I found out that there are three types of dynamic mesh define macros,ie DEFINE_CG_MOTION, DEFINE_GEOM, and DEFINE_GRID_MOTION. What type of macros shoud I use for solving the problem? The upper wall is moving as follows: r=r_mean + r_amp*sin(omega*time) r_mean = mean position r_amp= amplitude of postion omega=angula velocity(=1) If you can knw how to set up udf, could you please write it here for me? Your help would be greatly appreciated. Thanks again |
|
April 6, 2003, 12:55 |
Re: regarding dynamics mesh?
|
#2 |
Guest
Posts: n/a
|
Hi SUKI I'm having the same pb writing UDF for modeling oscillating and rotating NACA-foil movement, which cordinates are: X= R*(1.7*omega*t+sin(omega*t)). Y=R*cos(omega*t). where: R=radius=distance of pivot point (1/3 chord length) to centre of rotation. omega= angular velocity. my first pb is that I didn't get yet the licence and help files for Duynamic mesh, thus I don't know how strong is this utility. my second pb is that I wonder if I can't do that simply with moving wall option with specifying my wall (NACA)velocity coordinates!!!!! at last, what about the sliding mesh option? have you ever tried it? ******************************
|
|
April 6, 2003, 13:10 |
Re: regarding dynamics mesh?
|
#3 |
Guest
Posts: n/a
|
HI, caloggero
Is the dynamic mesh different in idea to sliding mesh? Under my problem, I have to use the first. thanks. |
|
April 6, 2003, 15:53 |
Re: regarding dynamics mesh?
|
#4 |
Guest
Posts: n/a
|
Hi
You can get acccess to Fluent information in the following address http://www.psc.edu/general/software/...f/main_pre.htm perhaps it can help you until you get the accest to fluent support. Regards Alex |
|
April 7, 2003, 03:49 |
Re: regarding dynamics mesh?
|
#5 |
Guest
Posts: n/a
|
thanx Alex, this is really helpful !
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |