|
[Sponsors] |
April 13, 2003, 12:25 |
Help Needed: Gambit Problem (2-D)
|
#1 |
Guest
Posts: n/a
|
Hi, My Friends:
I have a problem to plot my calculation domain(2-D). One part of its form is the function of y=tanh(x). Could I find this function in Gambit, and directly use it to plot the form of domain? (By the way, at present, I used a not good method to plot that part domain(y=tanh(x)). I input many points of this function into Gambit, then connected these points and smooth the curve to build the domain). If you could take the time and trouble to give me some advice, I would much appreciate it. |
|
April 13, 2003, 15:06 |
Re: Help Needed: Gambit Problem (2-D)
|
#2 |
Guest
Posts: n/a
|
Hi Collin
I guess what you should do is to generate your geometry on Autocad and then export it to gambit. Warning: perhap you will find some edges are not connected therefore you must to fix your geometry before meshing. Check on this web side how to import files from autocad to gambit http://www.udel.edu/topics/software/...uide/ugtoc.htm I don't think you will find a person in this discussion forum that will be able to address that problem. Therefore, I suggest that you contact Fluent user support, perhaps they can give you a better solution Regards Alex Munoz |
|
April 13, 2003, 18:16 |
Re: Help Needed: Gambit Problem (2-D)
|
#3 |
Guest
Posts: n/a
|
Thank you very much, Alex!
|
|
April 13, 2003, 20:45 |
Re: Help Needed: Gambit Problem (2-D)
|
#4 |
Guest
Posts: n/a
|
Hi
I forgot to tell you that you can write temperature profile in a surface Best regards Alex Munoz |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit geometry problem | cestrin | FLUENT | 3 | July 4, 2012 02:33 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
Help needed Centrifugal compressor problem | Raghavendra.M | FLUENT | 0 | December 23, 2008 23:44 |
Problem meshing with Gambit | Adrian | FLUENT | 8 | October 7, 2008 08:39 |
Problem importing iges file to Gambit | Tassos | FLUENT | 0 | May 7, 2008 04:28 |