Home > Forums > Software User Forums > ANSYS > FLUENT

Rotating reference mesh

Mark Forums Read

Reply

Search this Thread

April 30, 2003, 11:43	Rotating reference mesh	#1
Dennis Guest Posts: n/a	Hi, I was wondering if the mesh on either side of the interior wall of a rotating zone has to be identical? In my case I am attempting to model a simple four blade blower with flat blades. Thank You Dennis

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
[Commercial meshers] Conversion form .ccm to openFoam	ViktoriaE	OpenFOAM Meshing & Mesh Conversion	1	November 29, 2011 16:40
transient simulation of a rotating rectangle	icesniffer	CFX	1	August 8, 2009 07:25

All times are GMT -4. The time now is 11:57.