 |
 |
 |
|
|
|
[Sponsors] | ||||
June 26, 2003, 09:16
|
bed gradient
|
#1 |
|
Guest
Posts: n/a
|
Hi, I am modelling a 2d/3d open-channel flow, the experiment has a 3 different bed slopes. What is the most effective way of simulating the bed slope. Currently i tilt the whole model (in 2d) to an angle but reverse flow occurs during iteration and the flow prediction is screwed up. How do i overcome this problem?
thank you |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| specified shear at wall - temperature gradient - UDF - access violation error | senD | Fluent UDF and Scheme Programming | 9 | September 18, 2014 07:29 |
| how to model heat transfer inside a slow moving bed? | bigfans | FLUENT | 1 | October 9, 2009 00:12 |
| Pressure Gradient in channelOodles | sega | OpenFOAM Running, Solving & CFD | 14 | August 12, 2009 06:21 |
| can I use static enthalpy gradient to describe dT | Jay | CFX | 0 | August 6, 2008 23:01 |
| How to compute gradient for non-orthogonal grids? | Paul Hsieh | Main CFD Forum | 3 | November 11, 2003 04:52 |
Linear Mode
