|
[Sponsors] |
Frustrated Gambit Newbie:Please reply, Urgent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 17, 2003, 12:09 |
Frustrated Gambit Newbie:Please reply, Urgent
|
#1 |
Guest
Posts: n/a
|
I want half of a rectangle meshed using one mesh size and other half with another mesh size. For this i made a rectangle and added a vertex at opposite sides of the rectangle. I then used edge mesh for the sides of this one one face. Using face mesh gambit happily meshed one half of the rectangle fine but screwed up the other one. The screwed half doesnt come up with straight lines but with disfigured line , basically it doesnt match the vertices on the opposite sides. The mesh is quad and type is map. I always struggle with this thing whenever it comes to gambit , and sometimes i am luck and it draws straight brick meshes. Please tell me what i am doing wrong.
|
|
July 17, 2003, 22:36 |
Re: Frustrated Gambit Newbie:Please reply, Urgent
|
#2 |
Guest
Posts: n/a
|
Let me get this straight.
Are you meshing 1 face(rectangular) with different mesh size on the opposite edge? Or is it a volume and corresponding face? Or is it two adjacent (volume/face) ? Can you explain what were you trying to do? |
|
July 18, 2003, 04:56 |
Re: Frustrated Gambit Newbie:Please reply, Urgent
|
#3 |
Guest
Posts: n/a
|
No it is basically dividing a rectangle into two squares and meshing these squares with two different mesh sizes. There are no volumes involved. gambit meshes on square properly but doesnt mesh the other square properly. i hope it is clear. Thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unable to import the file in Gambit - urgent | Ricky | Main CFD Forum | 8 | August 20, 2008 13:56 |
urgent help needed for meshing in GAMBIT | chris | FLUENT | 0 | September 5, 2002 09:18 |
Urgent help needed for meshing in GAMBIT | John | FLUENT | 3 | September 4, 2002 09:08 |
Generating big meshes with GAMBIT on NT | Andrew Ooi | FLUENT | 12 | February 2, 2000 22:26 |
GAMBIT and Turbomachinery | tom | Main CFD Forum | 6 | October 21, 1999 09:50 |