|
[Sponsors] |
September 13, 2003, 12:59 |
stream contours in 3D geometry
|
#1 |
Guest
Posts: n/a
|
can any one tell how to get stream contours in 3D geometry??? thaanks
|
|
September 14, 2003, 08:06 |
Re: stream contours in 3D geometry
|
#2 |
Guest
Posts: n/a
|
I think you're referring to contours plot of the stream function.
If you want to plot them on a particular section of your 3D domain, just create the plane (Surface->Plane) on which that section lays and then plot contours choosing the plane you have created as plot surface and Stream Function in the drop down list. Hi ap |
|
September 14, 2003, 08:24 |
Re: stream contours in 3D geometry
|
#3 |
Guest
Posts: n/a
|
I did creat plane alrready..because to view the contours of velocity, tmperature etc. i created two planes... but i found no stream function option in the drop down list..
thanks regards |
|
September 14, 2003, 11:23 |
Re: stream contours in 3D geometry
|
#4 |
Guest
Posts: n/a
|
Sorry, I didn't read carefully your post.
For a 3D case, stream function is not available under the velocity category in the drop down list. Sorry again for the bad answer. Hi ap |
|
September 15, 2003, 00:45 |
Re: stream contours in 3D geometry
|
#5 |
Guest
Posts: n/a
|
its ok...SO there is no alternative to get stream contours in a 3D geometry????
thanks |
|
September 28, 2003, 05:06 |
Re: stream contours in 3D geometry
|
#6 |
Guest
Posts: n/a
|
deifine the surface and then export the result (velocity components) to another CAD forvisualisation. I Dot it with Tecplot
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Streamfunction? | cain | Main CFD Forum | 5 | July 19, 2012 10:05 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |