Home > Forums > Software User Forums > ANSYS > FLUENT

Coupling Fluent and Ansys for FSI

Mark Forums Read

Reply

Search this Thread

September 23, 2003, 04:33	Coupling Fluent and Ansys for FSI	#1
L-P Guest Posts: n/a	Hi I'm trying to couple Fluent with Ansys via an UDF with MDM. One problem that shows up is to know where the data on the surface is situated. In cell center in the nodes or anywhere else. Can I use interpolate function inside the udf.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to open Icem mesh in Ansys Fluent?	emmkell	FLUENT	27	February 6, 2018 03:34
Fluent Ansys temperature coupling	tensun	FLUENT	0	November 14, 2010 05:31
Fluent Ansys temperature coupling	tensun	Fluent UDF and Scheme Programming	0	November 14, 2010 05:30
few quesions on ANSYS ICEMCFD and FLUENT	Prakash.Paudel	ANSYS	0	August 12, 2010 12:07
FSI, Fluent Ansys coupling	Greg Carnie	FLUENT	5	January 7, 2010 19:15

All times are GMT -4. The time now is 21:20.