 |
 |
 |
|
|
|
[Sponsors] | ||||
September 26, 2003, 09:14
|
mesh motion
|
#1 |
|
Guest
Posts: n/a
|
Hi, all!
I'm working with dynamic mesh for a cone shape ventil used in oilhydraulic. when I check the "mesh motion", there is no error or wrong messages, but the mesh doesn't move. Whereas the animation of my ventil works well. What's wrong with this "mesh motion"? Is the time step size too big? Or should I set up "mesh motion" with some text command? any advice or comment is appreciated. Regards, emma |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 12 | April 10, 2013 00:44 |
| Dynamic moving mesh | Pei-Ying Hsieh (Hsieh) | OpenFOAM Running, Solving & CFD | 64 | June 7, 2012 10:04 |
| Mesh motion with Translation & Rotation | Doginal | CFX | 0 | August 3, 2011 16:37 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 6 | November 2, 2010 21:02 |
| Mesh motion on inlet (2-way FSI) | Lance | CFX | 2 | August 13, 2009 05:31 |
Linear Mode
