Help with 3D Two Phase Flow
 

I am currently working on an aerofoil partially submerged in water with air as the second phase. I have set the fluids to be imiscible with separate velocities. This should create a free surface with a wave over the aerofoil. However it is not solving. I am using Fluent 6, does anyone have any suggestions as to where my model could be going wrong.

Any help would be much appreciated.

Re: Help with 3D Two Phase Flow
 

Hi!

I've seen some simmilar simulations using VoF...maybe that's your answer.

Regards

MATEUS

Re: Help with 3D Two Phase Flow
 

Make sure that you are specifying your volume fractions correctly, i.e. vof1 and vof2.