|October 10, 2003, 04:38||
Boundary mass at the wall
Hi to all!!
1. Cw is the concentration at the wall boundary. This value is calculated along the area normal vector n.
2. A is a constant value and is equal to (V-K)/D, where V=0.000004 cm/sec, K=0.00000002 cm/sec and D=0.00000005 cm^2/sec.
3. I know the concentration C along all different directions x, y, z and n from former iterations. From all these values i want those who satisfy the normal gradient to the boundary.
4. The equation is Cw = ((V-K)/D) * dC/dn.
Thank you a lot!!!
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFX does not continue||Shafiul||CFX||10||February 17, 2011 08:57|
|how to set up a wall boundary condition according to calculated wall shear stress?||gameoverli||OpenFOAM Pre-Processing||1||May 21, 2009 08:28|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|
|mass fraction boundary value on a WALL ?||Alexey||CFX||1||September 3, 2004 00:54|
|Wall Boundary Mass||Vasilios Papaioannou||FLUENT||2||September 25, 2003 06:25|