Home > Forums > Software User Forums > ANSYS > FLUENT

symmetry BC

Mark Forums Read

Reply

Search this Thread

October 22, 2003, 13:18	symmetry BC	#1
siva Guest Posts: n/a	hi all, i have a 2d symmetric pipe with a mass flow inlet. do i have to enter half the mass flow rate at the inlet if im modeling only half the geometry? thanks for the help, siva

October 22, 2003, 23:05	Re: symmetry BC	#2
yayaya Guest Posts: n/a	yeah! You should! yayaya

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Blocking and Symmetry	BrolY	ANSYS Meshing & Geometry	32	August 24, 2012 03:13
Properly using symmetry with both CFX and ANSYS workbench for a FSI analysis, help!	Cirion0000	CFX	0	July 6, 2009 14:26
Forces in Symmetry	Matt	CFX	2	February 25, 2009 05:41
Symmetry plane error in solver	Santiago Orrego.	CFX	6	January 31, 2007 07:09
radiation and symmetry	Mark	FLUENT	2	November 4, 2004 13:50

All times are GMT -4. The time now is 04:23.