|
[Sponsors] |
November 5, 2003, 18:49 |
Re: Boundary Profile
|
#1 |
Guest
Posts: n/a
|
Hi, I applied BC with Boundary Profile. I checked with XY-plot and it is correct. After I ran FLUENT for one time step, I checked the profile again and found it changed.
Can anyone tell me why? Thanks for any help. Jeff |
|
November 18, 2003, 21:07 |
Re: Boundary Profile
|
#2 |
Guest
Posts: n/a
|
That shouldn't be, check whether it is overwritten by some output program. My intention is proceed as much time steps u want then look at the result.
Alamgir |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
velocity profile inlet boundary condition question | Lcw | FLUENT | 3 | August 3, 2012 05:53 |
Modeling of boundary layer wind profile in CFX 5 | Cuong NK | CFX | 7 | April 26, 2012 08:23 |
Boundary profile and initialization | shalu | FLUENT | 2 | July 28, 2006 07:32 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Boundary conditions profile | Christophe Doublet | FLUENT | 1 | June 14, 2001 00:27 |