|
[Sponsors] |
November 28, 2003, 01:58 |
customizing gambit
|
#1 |
Guest
Posts: n/a
|
hello,
I am doing a automation project- automating the creation and meshing of a particular geometry in gambit. wanted to know if gambit can be customised or programmed in such a way that it pops up some menus and asks for some values and based on that,it modifies the journal file. santosh |
|
December 3, 2003, 07:09 |
Re: customizing gambit
|
#2 |
Guest
Posts: n/a
|
that seems little difficult or impossible to me, but you can try otherway round ..i mean write a prog that writes a journal file. then run that journal in gambi tto get the final mesh.
zxaar |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open a saved Gambit File? | barkan | FLUENT | 5 | September 1, 2012 05:53 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |